Stratex | Deep Emboss Matt
Stratex | Deep Emboss Matt
SKU: 29-BRE-018
Add to Wishlist
The stylish sophistication of parquet in a high-tech board with a classic look - rich in red oak tones and rustic personality, capturing the vibrant character of antique wood. Brecon Vintage Oak is a lavish herringbone floor that's waterproof and has built-in underlay. Also available in matching plank.
| Pack Size | 7.75ft² |
|---|---|
| Bevels on Edges | Micro Bevel All 4 Edges |
| Core Material | Natural Mineral / Resin Composite |
| Finish | Deep Emboss Matte |
| Fitting Method | Floated |
| Floor Color | Natural |
| Floor Joint | Easiloc |
| Floor Thickness | 5mm |
| Floor Type | Stratex |
| Hardness | Hard |
| Length | 23 1/2 in |
| Planks per Pack | 10 |
| Tog Rating | 1.05 |
| Underfloor Heating | Suitable |
| Width | 4 3/4 in |
These are the questions we get asked most often about our floors and their features.
Yes – We recommend you let your Brecon floor acclimatise for at least 24 hours before installing. This needs to be in the same room that it will be installed in, and it needs to remain within the sealed packaging. The sealed packaging helps ensure the floor doesn’t warp with the change of temperature from different environments. Do not store the flooring outdoors, in an outbuilding, or anywhere with damp or condensation problems.
The surface immediately beneath a Woodpecker floor must be in good structural condition, free from damp rot, fungal or insect infestation, and contaminating residues. It must be flat with uneven areas not exceeding 3mm over a 2m area. Naturally, the surface should be vacuumed and totally free of debris before fitting begins. Hot pipes should be well insulated to prevent localised hotspots, which can cause Brecon flooring to distort.
Not in normal living conditions (temperatures of 15-25°C). However, allow a gap of 2-3mm for Brecon floors where there is likely to be temperature variation beyond normal living conditions. Eg. conservatories
Our cleaning kits for lacquered floors are suitable for your Brecon floor to keep them shining, alternatively use a well wrung damp mop.
The best way to conceal small scratches and marks on our Brecon range is with Scratchfix – a quick and easy method to restore scratches on resilient floors.
No – Brecon floors have built-in underlay therefore additional underlay should not be used. This can create additional bounce which can damage the joints. If you need to raise the height of the floor then we recommend using plywood.
Brecon is wood-effect flooring and as a result, it is waterproof. It has a stable mineral composite core and a resilient and slip-resistant vinyl.
No – Whilst Brecon is waterproof, long exposure to continuous water is not recommended, therefore bathrooms are fine but wet rooms would not be suitable.
Yes – You can use this floor with underfloor heating.
This floor has easiloc/click-joints.
This floor should only be floated.
The wear rating for Brecon is AC4.
Brecon has a slip resistance of R10.
Brecon is 5mm thick.
